The maximum inlet water temperature it can handle is 86 degrees F. The PowerStar is designed to heat potable cold water for domestic purposes. Wait until you are sure that it has completely thawed out.ĩ. Warning: Do not switch the heater on if you suspect that it may be frozen. The electrical installation must conform to current National Electrical Codes.Ĩ. Warning: Do not install a check valve or any other type of back flow preventer within ten feet of the cold water inlet.ħ. Warning: Do not install the heater in a location where it may be subject to freezing.Ħ. To reduce the risk of injury, close supervision is necessary when the product is used near children or elderly persons.ĥ. Disconnect this product from the electrical supply before cleaning, servicing or removing theĤ. ![]() ![]() When using this electrical equipment, basic safety precautions should always be followed, including the following:ģ.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |